No holes/transducer?

[Coastal1]

Is there some way to mount a transducer on a small boat without drilling into the transom/hull? I was thinking about adhesive to hold one of those poly boards on, not sure what they are made of but simular to a cutting board. Then screw the transducer into that. 5200 the board to the boat, would it hold? Maybe a 2 part epoxy of some type? Thanks in advance, R/Chip.

[Hardbound]

I have used 3-M 5200 on small boats with no screws straight to hull. Need to tape it or hold it in place until 5200 sets up.

[davecobb319]

My neighbor did exactly what you are talking about. If you message him I'm sure he wouldn't mind telling you what he used. His handle is axxell33