Tidal Fish Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
437 Posts
Discussion Starter · #1 ·
Have a alpha 1 merc 350 i/o that wont trim up going any faster than say 10mph...trims fine when going at lower speeds .It will go down when running but not up which is what you want . Been told its prolly the pump worn out as the prop is pushing it foward when at speed and it takes a lot of a$$ to push it back . Anyone else had this problem? Thanks , Bob
 

· Registered
Joined
·
113 Posts
I would say pump problem. May be pump end or motor end. Buy a new one and go fishing and not worry about it for a long while!
P.S. Make sure your connection is clean and elec. passes easily! Could have a voltage drop with poor connection. Both pos. and NEG!
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top