Tidal Fish Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
I have a set of planer boards that are tracking to the back of the boat any one have any ideas how to get it to track more to the center of the boat what i have is a two board 1 by 8 cut on a fifty degree angle from top to bottom and on thrity degree on the side.Do i need to move the eye bolt foward or recut the angles. Thanks
 

·
Registered
Joined
·
223 Posts
I wish I could help, butt I'm not fimilar with a two board setup. Maybe posting a picture of board would help identify the problem.
 

·
Registered
Joined
·
94 Posts
i run a three board set , they have 60degree angle from top to bottom and a 60 degree cut toward the boat and they pull very good . i got the plans from the internet and they were free. are you guys fishing this weekend
 

·
Registered
Joined
·
2,539 Posts
i just finished making another 3 board set. my set pulls great, i was just bored.... painted them key lime green

if yours are towards the rear of the boat they are not pulling hard enough. you can either fasten them forward on the boat or add stagger

 
1 - 7 of 7 Posts
Top