Tidal Fish Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,073 Posts
Discussion Starter · #1 ·
Here's the deal. Recently purchased a set of double mount bunk boards for the sides of the trailer I have my skiff on. They will fit OK but I need to find someone who can bend the "vertical mounts" to 90 degrees. Looks like about 2" square tubing that has been factory bent to about 60 degrees which is now too wide for the hull. If I mount them they will be too wide to accurately guide the hull on the trailer bunk boards. This is important because the hull of the skiff has strakes down the full length of the hull and the outboard starboard side has the scupper pickup for the fish well just outside one of the strakes. The hull sits on the trailer with the flat bunk boards just sitting between them. Anyone know of a shop in the central Anne Arundel county area with equipment that can finish the bend with some heat so the tubing doesn't collapse and complete the 90 degree angle?
 
1 - 3 of 3 Posts
Top